DilaSoft for Windows 32 bit Installation problems and failures:


If the install program fails, or displays any error message that does not allow the continuation of the install process, follow the directions below and try the install again. If this does not fix the problem, contact Theta Industries at the address below.



If setup is interrupted, subsequent attempts result in a "disk n not found". For a workaround remove the following files and re-attempt the setup: 

\WINDOWS\SYSTEM\VB6STKIT.DLL
\WINDOWS\SYSTEM\MSVBVM60.DLL
\WINDOWS\ST6UNST.EXE
\WINDOWS\SETUP.EXE
\WINDOWS\SETUP.LST
\WINDOWS\SETUP1.EXE
\WINDOWS\*.CAB

Note: There may be some '.cab' files in the '\windows\' directory that do belong there from the installation of other programs. All cab files installed by DilaSoft for Windows will start with the name "Theta", such as 'Thetaw1.cab'. It is safe to delete all files named "theta*.cab". The asterisk '*' (or 'star') is a wildcard character that will replace any other characters, so all cab files that start with 'theta' will be deleted.


Remove the following files *ONLY* if they are zero bytes in length: 

\WINDOWS\SYSTEM\SCRRUN.DLL (might not be found on all machines)
\WINDOWS\SYSTEM\OLEAUT32.DLL

The major cause for this error is that the cab files are not always removed after an aborted installation. This is because the code
assumes the cabs are extracted in numerical order which in most cases is not true. 



For more information, contact:

Theta Industries, Inc.
26 Valley Road
Port Washington, NY  11050
Phone: 516-883-4088
FAX: 516-883-4599
Email: theta@interactive.net


For DilaSoft for Windows _ONLY_:

Rich Schmitt
Bearly Computing
Phone: 716-229-2949
FAX: 716-229-4448
Email: bearlycomputing@attglobal.net